Choose this device to mesure an angular rotation or a distance if this device is associated with Draw Wire.
|Enable||Activate to enable the device|
|Run at startup||Activate to run the device at Kinetic startup|
|IP||Enter the ip address of your device. Your device and Modulo Player need to be in the same subnet|
|Port||TCP/IP port. 6000 is the default value (usually doesn’t need to be changed)|
|Filter enable||if activated you need to enter a filter value to reduce latency|
|Filter value||set the filter value|
|Setup UDP mode||The encoder needs a specific internal setup to works correctly with Modulo Player. Click on this button to force the correct settings|
|Set CW||Set the positive counting to clockwise|
|Set CCW||Set the positive counting to counter-clockwise|
|Reset Offset||Set a default value to 100 000|
|Set IP||Setup a new IP to your encoder|
You can use this device in a Digimap.
Go there to have more information on this device.
Need more help with this?
Don’t hesitate to contact us here.