Deltacast

You can use a Deltacast capture card in order to capture a HDMI or HD-SDI, on SDI, DVI video stream. You can handle it as a media.

General:

For HD-SDI input board type:
Configure settings in order to display media from the acquisition cards.

For HDMI input board type:

Setup:

For HD-SDI input board type:

You need first to choose the reference VNode in the menu Project/Project settings/General Tab/ Reference VNode field: The available source will be searched on this VNode.

You can display a video thumbnail of the stream.
Click on the auto setup button to do an autosetup on the incoming signal.
Once the signal is set, the indication becomes from red to green.

*NB: This function will autoset input type, width and height, HQ option, framerate and deinterlacement.

For HDMI input board type:

You need first to choose the reference VNode in the menu Project/Project settings/General Tab/ Reference VNode field: The available source will be searched on this VNode.

You can display a video thumbnail of the stream.
Click on the auto setup button to do an autosetup on the incoming signal.
Once the signal is set, the indication becomes from red to green.

*NB: This function will autoset input type, width and height, HQ option, framerate and deinterlacement.

You can force the EDID of the HDMI input source directly in Modulo Kinetic Designer remotly. To do so, click on the force EDID button and select the appropriate EDID for the incoming signal.
It’s possible to check “Force all VNode” to do a force EDID on all VNode in your show.
Once you click Apply, the computer (input source) will flash briefly. Once the EDID forced, a green notice will appear for some seconds confirming that the EDID was loaded with success. Click on Back to return to the deltacast window, and click on Autosetup.
It’s possible to use a custom EDID (User tab). If the EDID is not already in the list you can copy it manually to the Kinetic Designer Documents folder > Modulo Kinetic> deltacast_edid folder and use them in the user tab.