Choose this device to control your Projectiondesign video-projectors.
Settings:
| Name | User-friendly name |
|---|---|
| Enable | Activate to enable the device |
| Run at startup | Activate to run the device at Kinetic startup |
| IP | Enter the ip address of your video projector. Your device and Kinetic Designer need to be in the same subnet |
| Port | Choose port number. Port. 1025 is the default value (usually doesn’t have to be changed |
Task action:
| Enable device | enable the device |
|---|---|
| Disable device | disable the device |
| Power On | send Projectiondesign power on command |
| Power Off | send Projectiondesign power off command |
| Lamp mode | select lamp mode |
| Shutter On | send Projectiondesign shutter on command |
| Shutter Off | send Projectiondesign shutter off command |
| Channel | select channel value |
| Freeze On | send Projectiondesign freeze on command |
| Freeze Off | send Projectiondesign freeze off command |
Task trigger:
N/A
Digimap trigger:
N/A
Graph:
N/A
User interface:
You can add this device in any user panel. You can then choose the available features in the panel.
Device information:
Go to Barco website for more information.
Need more help with this?
Don’t hesitate to contact us here.