Choose this device to connect to a PhidgetSpatial Precision 0/0/3 High Resolution 1043_1B
You can then receive Accelerometer value and use it with a Digimap.
Settings:
| Name | User-friendly name |
|---|---|
| Enable | Activate to enable the device |
| Run at startup | Activate to run the device at Kinetic startup |
| Serial Number: | Enter the serial number of the VINT HUB Phidget |
| Port: | Choose port number of the VINT HUB Phidget |
| interval ms: | Choose the refresh interval in milliseconds |
Task action:
N/A
Task trigger:
Trigger a task according to the incoming parameter:
Entry:
| X axis | select the X axis incoming value |
|---|---|
| Y axis | select the Y axis incoming value |
| Z axis | select the Z axis incoming value |
Condition:
| greater than | trigger the task when the incoming value is superior to the condition value |
|---|---|
| less than | trigger the task when the incoming value inferior,to the condition value |
| greater than or equal to | trigger the task when the incoming value is superior or equal to the condition value |
| less than or equal | trigger the task when the incoming value is inferior or equal to the condition value |
| eguals | trigger the task when the incoming value is equal to the condition value |
| range | trigger the task when the incoming value is superior to the condition value min and inferior to value max |
Value:
Set the condition value
Hysteresis:
For all theses conditions, you can set a hysterys value to avoid false triggering.
For example you use the > condition with a value of 0.5, you set an hysterys value of 0.1. When the incoming value reach 0.5, the task is triggered.
If the incoming value go back to 0.45 then go to 0.5, the task is not triggered.
If the incoming value go back to 0.35 (less than condition value – hystererys value) then go to 0.5, the task is triggered.
Digimap trigger:
Select the accelerometer axis X or Y or Z.
Graph:
| Acceleration | get the acceleration measured |
|---|
User interface:
You can add this device in any user panel.
You can then display the X,Y and Z values.
Device information:
Go to this page for more information.
Need more help with this?
Don’t hesitate to contact us here.