Choose this device to control Analog Way VIO series.
Settings:
| Name | User-friendly name |
|---|---|
| Enable | Activate to enable the device |
| Run at startup | Activate to run the device at Kinetic startup |
| IP | Enter the ip address of your device. Your device and Kinetic Designer need to be in the same subnet |
| Port | Choose port number. Port. 10600 is the default value (usually doesn’t have to be changed) |
Task action:
| Enable device | enable the device |
|---|---|
| Disable device | disable the device |
| Load Preset from Memory | load preset index from memory |
| Set Source | set source index |
| Load View from memory | allows to load a previously memorized view to apply on specified input layer |
| Load View from memory to active input | allows to load a previously memorized view to apply on active input layer |
| Take | send a take command |
| Select Manual Mode | this command disables the automatic commutation |
| Select Auto Apply Mode | This command enables the automatic commutation |
| Reboot | this command restarts the device |
| Wake up | this command wakes up the device |
| Stand by | this command puts the device on standby |
| Power Off | this command shuts down and powers off the device |
Task trigger:
N/A
Digimap trigger:
N/A
Graph:
N/A
User interface:
N/A
Device information:
Go to the manufacturer website for more information.
Need more help with this?
Don’t hesitate to contact us here.