Angular Speed

Calculate the angular speed of every item in an array based on it’s X and Y coordinates.

Generally used on the tracking data of rotating objects.

It adds the following properties to the input array :

• Angle
• Vangle (for speed)
  

*Note : The Angle property will accumulate over time as the angular speed is tracked and computed. Its sign will follow trigonometry rules.

How to use this node

To use this node you must define a disc area where tracking data will be computed by setting coordinates for a center and two values of radii.

These properties are present in the Editor panel when the node is selected.

The disc area is defined by a Minimum (Min R) and a Maximum (Max R) radius. The minimum value can not be more than the maximum value so take care to set the latter one first.

Tracking data outside the disc formed by the above properties will be ignored in the computation.

For computation to be precise, the movement tracked must revolve around the center point.

Properties

• Unit : Choose between Radian and Degrees for the output of the angle value.
  Default : Rad

• Center X : X coordinate for the center of the tracking zone.
  Default : 0.0

• Center Y : Y coordinate for the center of the tracking zone.
  Default : 0.0

• Min R : Minimum radius under which tracking data will be ignored in the computation.
  Default : 0.1

• Max R : Maximum radius over which tracking data will be ignored in the computation.
  Default : 1.0

• Process noise covariance : Sensitivity for noise in the prediction part of the algorithm
  Default : 0.5

• Measure noise covariance : Sensitivity for noise in the correction part of the algorithm
  Default : 0.5

• State post covariance : Sensitivity for the initial measure taken in account by the algorithm
  Default : 10

Inputs

Outputs

Examples

In this example Unit was set to Degrees

All other properties were left at default values.