Math

This section contains a set of nodes to perform basic and complex mathematical operations.

Math nodes

• Absolute : Output the absolute of a number
• Accumulator : Output a float that gradually increases or decreases over time
• Clamp : Constrain a float between two thresholds
• Modulo : Perform a modulo operation
• Operation : Perform basic mathematical operations (+, -, x, /)
• Bit Operator : Perform bitwise operations on integers
• Pow : Perform an exponentiation operation
• Input Edge : Outputs the highest and lowest numbers reached by a variating value
• Vector Normalization : Normalizes a vector
• Vector Operation : Perform basic operations (+, -, x, /) on vectors
• Vector Length : Outputs the length of a vector
• Vector Target : Computes the target vector between two vectors
• Lerp : Performs a Linear Interpolation between two values
• Rad / Deg Converter : Converts Radian to Degrees or vice versa
• Floor / Ceil / Round : Output an approximation of a value (three modes available)
• Exp / Log : Performs the exponent or logarithmic operations
• Min / Max : Compare two values and output either the lowest (Min Mode) or the highest (Max Mode)
• Square Root : Computes the square root of a value
• Sin / Cos / Tan : Performs the Sine, Cosin or Tangent operations or their inverse