Retake the autocalibration on an existing installation

If you have a system of projectors and servers in place, like in a permanent installation, you may want to retake the actual autocalibration.
For instance, after a video projector is replaced, you simply need to operate the autocalibration with the same parameters you did in the past.

To achieve this:

• Power on all your projectors and the camera
• Be sure there is no undesirable lights in the place of your projection
• Open your project in Modulo Kinetic Designer
• Then, go into the menu bar > V-Nodes > Autocalibration
  

• The autocalibration window will pop-up and remind you to prepare the environment
• When you are ready, click on Next

• At this moment, click on the One-click calib button

• The autocalibration will operate straight
• Wait until the calibration is done