Choose this device to mesure an angular rotation or a distance if this device is associated with Draw Wire.
Settings:
| Name | User-friendly name |
|---|---|
| Enable | Activate to enable the device |
| Run at startup | Activate to run the device at Kinetic startup |
| IP | Enter the ip address of your device. Your device and Modulo Player need to be in the same subnet |
| Port | TCP/IP port. 6000 is the default value (usually doesn’t need to be changed) |
| Filter enable | if activated you need to enter a filter value to reduce latency |
| Filter value | set the filter value |
Hardware setup:
| Setup UDP mode | The encoder needs a specific internal setup to works correctly with Modulo Player. Click on this button to force the correct settings |
|---|---|
| Set CW | Set the positive counting to clockwise |
| Set CCW | Set the positive counting to counter-clockwise |
| Reset Offset | Set a default value to 100 000 |
| Set IP | Setup a new IP to your encoder |
Task action:
N/A
Task trigger:
N/A
Digimap trigger:
You can use this device in a Digimap.
Graph:
N/A
User interface:
N/A
Device information:
Go there to have more information on this device.
Need more help with this?
Don’t hesitate to contact us here.