Choose this device to control analog outputs and mesure analog values using Modbus with this device ADAM-6224
Settings:
| Name | User-friendly name |
|---|---|
| Enable | Activate to enable the device |
| Run at startup | Activate to run the device at Kinetic startup |
| IP | Enter the ip address of your device. Your device and Kinetic Designer need to be in the same subnet |
| Port | TCP/IP port. 502 is the default value (usually doesn’t have to be changed) |
| Type | Choose the ADAM-6224 or the generic Modbus version |
| Visual Mode | Choose the visual mode (V or mA) |
|---|---|
| min | Enter the minimal value of the range |
| max | Enter the maximal value of the range |
If you select Generic, you need to enter the following information:
| Precision | adjust the DAC precision (8/12/16 bits) |
|---|---|
| Inputs | Number of digital inputs |
| Outputs | Number of digital outputs |
| Start input address | Modbus input register address |
| Start output address | Modbus output register address |
Task action:
| Enable device | enable the device |
|---|---|
| Disable device | disable the device |
| Switch outputs | Select the outputs you want to change and the corresponding values you want |
.
Task trigger:
N/A
Digimap trigger:
N/A
User interface:
N/A
Graph:
N/A
Device information:
You can use for example the ADAM-6224
Need more help with this?
Don’t hesitate to contact us here.