Timeline creation and basic warp

Add the media Cube Pattern.png on the timeline.

The image should be projected on your projector.

If not, try right clicking on the Output and selecting Display on second screen. Check your connections.

Warp in Keystone mode

Select the Output and in the Shape tab.

Set the Curve Type to Keystone.

Open the Warp panel and move the 4 corners to try and fit the pattern on the cube.

Notice that this isn’t easy and that the result isn’t satisfying.

Warp in Curve mode

In the Shape tab, switch the Curve type to Curve. Add a few columns/rows if needed. Use at least 3.

Try to fit the pattern on the cube again. You can increment the number of control points if needed.

Notice that although the result is better, the warping is a little tedious.