Choose this device to connect to a 8 Voltage Input Phidget DAQ1000_0
For applications where you just need a lot of sensors, the 8x Voltage Input Phidget adds eight 0-5V analog inputs to your VINT Hub (See the Connection & Compatibility tab for a list of Hubs).
Each input can be used in one of two modes: VoltageInput or VoltageRatioInput.
With VoltageInput mode, you simply measure a voltage value from 0 to 5V. This mode is useful for interfacing 5V sensors and for monitoring small voltages.
In VoltageRatioInput mode, you can read ratiometric sensors like potentiometers and voltage dividers, whose output voltage depend on their input voltage.
The return voltage is expressed as a ratio of the return voltage to the supply voltage from 0.0 to 1.0.
Settings:
| Name | User-friendly name |
|---|---|
| Enable | Activate to enable the device |
| Run at startup | Activate to run the device at Kinetic startup |
| Serial Number: | Enter the serial number of the VINT HUB Phidget |
| Port: | Choose port number of the VINT HUB Phidget |
Choose for each input if you want to work in voltage or ratio mode,and you can assign a specific type to the sensor.
Task action:
N/A
Task trigger:
Trigger a task according to the incoming parameter:
Entry:
| IN 0 | select input port 0 |
|---|---|
| IN 1 | select input port 1 |
| IN 2 | select input port 2 |
| IN 3 | select input port 3 |
| IN 4 | select input port 4 |
| IN 5 | select input port 5 |
| IN 6 | select input port 6 |
| IN 7 | select input port 7 |
Condition:
| greater than | trigger the task when the incoming value is superior to the condition value |
|---|---|
| less than | trigger the task when the incoming value inferior,to the condition value |
| greater than or equal to | trigger the task when the incoming value is superior or equal to the condition value |
| less than or equal | trigger the task when the incoming value is inferior or equal to the condition value |
| eguals | trigger the task when the incoming value is equal to the condition value |
| range | trigger the task when the incoming value is superior to the condition value min and inferior to value max |
Value:
Set the condition value
Hysteresis:
For all theses conditions, you can set a hysterys value to avoid false triggering.
For example you use the > condition with a value of 0.5, you set an hysterys value of 0.1. When the incoming value reach 0.5, the task is triggered.
If the incoming value go back to 0.45 then go to 0.5, the task is not triggered.
If the incoming value go back to 0.35 (less than condition value – hystererys value) then go to 0.5, the task is triggered.
Task trigger:
N/A
Digimap trigger:
Use the selected input voltage as an input for Digimap.
Graph:
| Get in 0 | get the voltage on IN 0 |
|---|---|
| Get in 1 | get the voltage on IN 1 |
| Get in 2 | get the voltage on IN 2 |
| Get in 3 | get the voltage on IN 3 |
| Get in 4 | get the voltage on IN 4 |
| Get in 5 | get the voltage on IN 5 |
| Get in 6 | get the voltage on IN 6 |
| Get in 7 | get the voltage on IN 7 |
User interface:
You can add this device in any user panel.
You can then display the input voltage.
Device information:
Go to this page for more information.
You need to plug this device to a VINT HUB Phidget.
Need more help with this?
Don’t hesitate to contact us here.