Choose this device to connect to a PhidgetInterfaceKit 8/8/8 1018_2B
Analog Inputs
The analog inputs are used to measure continuous voltage outputs generated by various sensors such as temperature, humidity, position, or pressure.
Phidgets offer a wide variety of sensors that can be plugged directly into the board using the cable included with the sensor.
Sampling rates can be set at 1ms, 2ms, 4ms, 8ms and multiple of 8ms up to 1000ms.
For more information about these inputs and their connectors, have a look at the Analog Input Primer.
Digital Inputs
The Digital Inputs have a Digital Input Hardware Filter to eliminate false triggering from electrical noise.
They can be used to convey the state of devices such as push buttons, limit switches, relays, and logic levels.
Digital Outputs
The Digital Outputs can be used to drive LEDs, solid state relays (such as the 3052 SSR Relay Board), transistors,… anything that will accept a CMOS signal.
Settings:
Name: User-friendly name
Serial Number: Enter the serial number of the device
Choose for each voltage input if you have to receive the voltage or ratio, the voltage sensor type and the refresh interval.
Task action:
You can select some outputs and assign a voltage value.
Task trigger:
You can trigger a task on a change of the state of the inputs.
Digimap trigger:
The incoming value is patched to this Digimap.
User interface:
N/A
Device information:
Go to this page for more information.
Need more help with this?
Don’t hesitate to contact us here.