Choose this device to control your Sanyo video-projectors.
Settings:
Name: User-friendly name
Serial/IP : Choose serial or IP
IP: Enter the ip address of your video projector. Your device and Modulo Player need to be in the same subnet
Port: TCP/IP port. 1000 is the default value (usually doesn’t have to be changed)
ID: Optional ID (herited from old RS232 protocol)
Authentification Off/On: Enables the authentification. Most of the time, it’s necessary to activate the authentification. You need to match the settings in your projector with this setup
Password: If authentification is enabled, you need to enter the password corresponding to your device. If you don’t know the password, go to the user manual of your video projector and search for protocol, you will find the default password
Task action:
Command available:
Power On/Off
Channel (value)
Freeze On/Off
Picture Mute On/Off
Task trigger:
N/A
Digimap trigger:
N/A
User interface:
N/A
Device information:
Need more help with this?
Don’t hesitate to contact us here.