Select this device to control your Barco video-projectors RLM series.


Name User-friendly name
Enable Activate to enable the device
Run at startup Activate to run the device at Kinetic startup
IP Enter the ip address of your video projector. Your device and Kinetic Designer need to be in the same subnet
Port: Choose port number. Port. 43680 is the default value (usually doesn’t have to be changed

Task action:

Enable device enable the device
Disable device disable the device
Power On send Barco power on command
Power Off send Barco power off command
Lamp Mode choose lamp mode from the list
Channel select channel number
Shutter On send Barco shutter on command
Shutter Off send Barco shutter off command
Mute On send Barco mute on command
Mute Off send Barco mute off command
Test Pattern choose test pattern from the list
OSD On send Barco OSD on command
OSD Off send Barco OSD off command
Projection Front select projection front mode
Projection Rear select projection rear mode
Projection Floor select projection floor mode
Projection Ceiling select projection ceiling mode
SetLampPower set lamp power value
LoadLensMemory recall lens memory value
SaveLensMemory save lens memory value
SetLampscCount set lamps count value
Focus increase increase focus value
Focus decrease decrease focus value
Zoom increase increase zoom value
Zoom decrease decrease zoom value
Horizontal Shift increase increase horizontal shift value
Horizontal Shift decrease decrease horizontal shift value
Vertical Shift increase increase vertical shift value
Vertical Shift decrease decrease vertical shift value

Task Trigger:


Digimap Trigger:




User Interface:

You can add this device in any user panel. You can then choose the available features in the panel.

Device Information:

Go to Barco website for more information.

Need more help with this?
Don’t hesitate to contact us here.

Thanks for your feedback.