Choose this device to send and receive UDP packet to/from other devices.
|Enable||Activate to enable the device|
|Run at startup||Activate to run the device at Kinetic startup|
|IP||Enter your device ip address . Your device and Kinetic Designer need to be in the same subnet|
|Port||Choose the correct UDP port|
|Enable device||enable the device|
|Disable device||disable the device|
|Send Command||you have to enter the ASCII character string you want to send *|
You can trigger a task sending an ASCII string.
You need to enter the same ASCII command in the message field.
You can trigger a digimap sending an ASCII command.
The syntax is : name_of_your_command?value
For example, it can be /modulo/x?124.213: You then choose the message /modulo/x and you will receive the value 124.213 in your Digimap.
You need to enter the name of your ASCII command in the message field.
|Receive value||receive value from tcp device|
|Send message||send message on tcp device|
To test your device you can use this free tools.
Need more help with this?
Don’t hesitate to contact us here.