This device allows you to control Panasonic video-projectors and many other brands that support this protocol.
Settings:
| Name | User-friendly name |
|---|---|
| Enable | Activate to enable the device |
| Run at startup | Activate to run the device at Kinetic startup |
| IP | Enter the ip address of your video projector. Your device and Kinetic Designer need to be in the same subnet |
| Port | Choose port number. Port. 4352 is the default value (usually doesn’t have to be changed |
| Authentification | Enables the authentification. Most of the time, it’s necessary to activate the authentification. You need to match the Pjlink settings in your projector with this setup |
| Password | If authentification is enable, you need to enter the password corresponding to your device. If you don’t know the password, go to the user manual of your video projector and search for PjLink, you will find the default password |
Task action:
| Enable device | enable the device |
|---|---|
| Disable device | disable the device |
| Power On | send Pjlink power on command |
| Power Off | send Pjlink power off command |
| Picture Mute On | send Pjlink picture mute on command |
| Picture Mute Off | send Pjlink picture mute off command |
| Input RGB | select input RGB source number |
| Input Video | select input video source number |
| Input Digital | select input digital source number |
| Input Storage | select input storage source number |
| Input Network | select input network source number |
| Shutter On | send Pjlink shutter on command |
| Shutter Off | send Pjlink shutter off command |
Task trigger:
N/A
Digimap trigger:
N/A
Graph:
N/A
User interface:
You can add this device in any user panel. You can then choose the available features in the panel.
Device information:
Go to the manufacturer website for more information.
Need more help with this?
Don’t hesitate to contact us here.