Select this device to control Barco UDX or F-series video projectors.
|Name||Barco VP||User-friendly name.|
|Enable||ON||Toggle to enable/disable the device.|
|Run at startup||ON||Toggle to enable the device when Kinetic Designer is launched.|
|Type||HDX/UD||Select the Barco projector type.|
|IP||[empty]||Set the IP address of your device. Your device and Kinetic Designer should be on the same subnet.|
|Port:||43680||TCP/IP port used by the device.|
|ID||0||Set the projector ID.|
|Enable device||Enable the device|
|Disable device||Disable the device|
|Power On||Send Barco power on command|
|Power Off||Send Barco power off command|
|Lamp On||Send Barco lamp on command|
|Lamp Off||Send Barco lamp off command|
|Shutter On||Send Barco shutter on command|
|Shutter Off||Send Barco shutter off command|
|Mute On||Send Barco mute on command|
|Mute Off||Send Barco mute off command|
|Channel||Select channel number|
|Freeze On||Send Barco freeze on command|
|Freeze Off||Send Barco freeze off command|
|Focus Increase||Increase focus value|
|Focus Decrease||Decrease focus value|
|Zoom Increase||Increase zoom value|
|Zoom Decrease||Decrease zoom value|
|Shift Horizontal Increase||Increase horizontal shift value|
|Shift Horizontal Decrease||Decrease horizontal shift value|
|Shift Vertical Increase||Increase vertical shift value|
|Shift Vertical Decrease||Decrease vertical shift value|
|Laser Power Eco Mode (PGWU)||Select Laser Power Eco Mode (only for PGWU)|
|Laser Power Normal (PGWU)||Select Laser Power normal Mode (only for PGWU)|
|Laser Power Power (PGWU)||Select Laser Power power Mode (only for PGWU)|
|Laser Power Value (PGWU)||Select Laser Power value Mode (only for PGWU)|
|Aspect Ratio (G60)||Set aspect ratio from the list (only for G60)|
|Color Temp (G60)||Set color temperature from the list (only for G60)|
|Display Mode (G60)||Set display mode from the list (only for G60)|
|Standby Power Mode(G60)||Set standby power mode from the list (only for G60)|
|Test Pattern (G60)||Set test pattern from the list (only for G60)|
|Light Source (G60)||Set light source from the list (only for G60)|
|Constant Power (G60)||Set constant power value from the list (only for G60)|
This device has no actions that can trigger a Task.
This device cannot be used as a Digimap trigger.
This device has no properties that can be read or written from a Graph.
When drag & dropped into a UI Panel the following commands are available:
Check Barco’s website for more information on their video projectors.
Need more help with this?
Don’t hesitate to contact us here.