Choose this device to connect to a Phidgets 4A DC Motor DCC1002_0
The DCC1002 gives you complete control of one medium to large DC motor from one of the ports on your VINT hub. You can control motor velocity, acceleration and braking strength using commands from your software. The compact and enclosed form factor of the DCC1002 makes it easy for this Phidget to fit in smaller projects while still controlling motors with current ratings of up to 4 amps.


Name User-friendly name
Enable Activate to enable the device
Run at startup Activate to run the device at Kinetic startup
Serial Number: Enter the serial number of the VINT HUB Phidget
Port: Choose port number of the VINT HUB Phidget
Data Interval ms: Choose the refresh interval in milliseconds
Reset position: Set the current motor position as the zero position
Engaged: Need to be active to move the motor
Acceleration Set acceleration value*
Velocity max Set velocity max value*
Target position Set target position value*
Kp Set Kp value*
Ki Set Ki value*
Kd Set Kd value*
Dead Band Set dead band value*
Power limit Set power limit value*

Task action:

Enable device enable the device
Disable device disable the device
Set engaged enble/disable engaged option
Set limit [ set power limit value
Set target position set target position value
Set velocity Set velocity value
Set acceleration set acceleration value
Zeroing sets the current motor’s value as home value
Go to set acceleration/velocity/target position

Task trigger:


Digimap trigger:

You can use the position of the motor as a input value for Digimap.


Get position get the absolute position

User interface:


Device information:

Go to this page for more information.
You need to plug this device to a VINT HUB Phidget.

Need more help with this?
Don’t hesitate to contact us here.

Thanks for your feedback.