Setup on V-Node server

Connecting projectors to the Modulo V-Node

Connect the devices to the proper connectors on the graphics card. The order is from top to bottom.

Connector :

1. Video projector 1 for the cyclo left side
2. Video projector 2 for the cyclo right side
3. Reminder projector
4. Speaker feedback
   

Force EDID

We will now force EDIDS and create an extended desktop with 4 screens :

• In the menu, go to V-Node > Remote Settings.
• Select your V-Node in the list on the left.
• Go to the AMD tab and the EDID subtab.
• Select the first 4 outputs and choose an EDID 1920×1080@50P from the list and click on Force EDID.

*The outputs of the graphics card may flash several times but a message indicates on the remote that the operation is successful.

Create Eyefinity

• Select your V-Node in the list on the left.
• Go to the AMD tab and the Eyefinity subtab.
• Select the first 4 outputs and click on Create Eyefinity. We’ll choose an arrangement of 4 horizontal screens (Cols : 4 — Rows : 1).

*The outputs of the graphics card may flash several times but a message indicates on the remote that the operation is successful.

• In the Control tab click on Start V-Node.
  The server indicator light should turn from red to orange. This means it is ready.
• Note the IP address of the V-Node for the next step.

Setup the V-Node on Kinetic Designer

• Add a V-Node and name it.
• Set its IP Address to the address from the previous step.
• Click on the V-Node and in the Editor panel, Settings tab set the size of the V-Node’s EYEFINITY which is 7680×1080.

*The V-Node is setup, however it is not yet ready to display content until it is affected to a Render Surface.