Select this device to control Christie Digital video projectors.
|Toggle to enable/disable the device.
|Run at startup
|Toggle to enable the device when Kinetic Designer is launched.
|Set the IP address of your device. Your device and Kinetic Designer should be on the same subnet.
|TCP/IP port used by the device.
|Set the projector ID.
|Enable the device
|Disable the device
|Send Christie power on command
|Send Christie power off command
|Send Christie shutter on command
|Send Christie shutter off command
|Select channel number
|Select channel PIP number
|Send Christie freeze on command
|Send Christie freeze off command
|Freeze PIP On
|Send Christie freeze PIP on command
|Freeze PIP Off
|Send Christie freeze PIP off command
|Internal Test Pattern
|Choose internal test pattern from the list
|Send Christie PIP on command
|Send Christie PIP off command
|Picture Mute On
|Send Christie picture mute on command
|Picture Mute Off
|Send Christie picture mute off command
This device has no actions that can trigger a Task.
This device cannot be used as a Digimap trigger.
This device has no properties that can be read or written from a Graph.
When drag & dropped into a UI Panel the following commands are available:
Check Christie Digital’s website for more information on their video projectors.
Need more help with this?
Don’t hesitate to contact us here.