Select this device to control Titan Digital Projection video projectors.
|Toggle to enable/disable the device.
|Run at startup
|Toggle to enable the device when Kinetic Designer is launched.
|Set the IP address of your device. Your device and Kinetic Designer should be on the same subnet.
|TCP/IP port used by the device.
|Enable the device
|Disable the device
|Send Digital Projection power on command
|Send Digital Projection power off command
|Send Digital Projection shutter on command
|Send Digital Projection shutter off command
This device has no actions that can trigger a Task.
This device cannot be used as a Digimap trigger.
This device has no properties that can be read or written from a Graph.
When drag & dropped into a UI Panel the following commands are available:
Check Digital Projection’s website for more information on their video projectors.
Need more help with this?
Don’t hesitate to contact us here.