Select this device to control Optoma video projectors.


Property Default Description
Name Optoma User-friendly name.
Enable ON Toggle to enable/disable the device.
Run at startup ON Toggle to enable the device when Kinetic Designer is launched.
IP [empty] Set the IP address of your device. Your device and Kinetic Designer should be on the same subnet.
Port 23 TCP/IP port used by the device.

Manual controls of the Optoma device in the Editor panel.Manual controls of the Optoma device in the Editor panel.

Task action

Action Description
Enable device Enable the device
Disable device Disable the device
Power On Send Optoma power on command
Power Off Send Optoma power off command
Shutter On Send Optoma close shutter command
Shutter Off Send Optoma open shutter command
Input Select the input to display
Freeze On Send Optoma Freeze On command
Freeze Off Send Optoma Freeze Off command
Focus Increase Send Optoma Focus + command
Focus Decrease Send Optoma Focus – command
Zoom Increase Send Optoma Zoom + command
Zoom Decrease Send Optoma Zoom – command
Horizontal Shift Set horizontal shift value
Vertical Shift Set vertical shift value
Internal test pattern Select an internal test pattern to display
Aspect Ratio Set the aspect ratio to display

Task trigger

This device has no actions that can trigger a Task.

Digimap trigger

This device cannot be used as a Digimap trigger.


This device has no properties that can be read or written from a Graph.

User interface

When drag & dropped into a UI Panel the following commands are available:

Manual controls of the Optoma device in a UI panel.Manual controls of the Optoma device in a UI panel.

Device information

Check Optoma’s website for more information on their video projectors.

Need more help with this?
Don’t hesitate to contact us here.

Thanks for your feedback.