Choose this device to monitor a temperature/humidity sensor Papago 2TH
Settings:
| Name | User-friendly name |
|---|---|
| Enable | Activate to enable the device |
| Run at startup | Activate to run the device at Kinetic startup |
| IP | set the device IP adress; Your device and Kinetic Designer need to be in the same subnet |
Monitor directly the temperature and humidity in this panel.
Task action:
N/A
Task trigger:
Trigger a task according to the incoming parameter:
Condition:
| greater than | trigger the task when the incoming value is superior to the condition value |
|---|---|
| less than | trigger the task when the incoming value inferior,to the condition value |
| greater than or equal to | trigger the task when the incoming value is superior or equal to the condition value |
| less than or equal | trigger the task when the incoming value is inferior or equal to the condition value |
| eguals | trigger the task when the incoming value is equal to the condition value |
| range | trigger the task when the incoming value is superior to the condition value min and inferior to value max |
Value:
Set the condition value
Hysteresis:
For all theses conditions, you can set a hysterys value to avoid false triggering.
For example you use the > condition with a value of 0.5, you set an hysterys value of 0.1. When the incoming value reach 0.5, the task is triggered.
If the incoming value go back to 0.45 then go to 0.5, the task is not triggered.
If the incoming value go back to 0.35 (less than condition value – hystererys value) then go to 0.5, the task is triggered.
Digimap trigger:
N/A
User interface:
You can add this device in any user panel.
You can then choose the available features in the panel.
Graph:
N/A
Device information:
Go to the manufacturer website for more information.
Need more help with this?
Don’t hesitate to contact us here.