Choose this device to mesure an angular rotation or a distance if this device is associated with Draw Wire.


Name User-friendly name
Enable Activate to enable the device
Run at startup Activate to run the device at Kinetic startup
IP Enter the ip address of your device. Your device and Modulo Player need to be in the same subnet
Port TCP/IP port. 6000 is the default value (usually doesn’t need to be changed)
Filter enable if activated you need to enter a filter value to reduce latency
Filter value set the filter value

Hardware setup:

Setup UDP mode The encoder needs a specific internal setup to works correctly with Modulo Player. Click on this button to force the correct settings
Set CW Set the positive counting to clockwise
Set CCW Set the positive counting to counter-clockwise
Reset Offset Set a default value to 100 000
Set IP Setup a new IP to your encoder

Task action:


Task trigger:


Digimap trigger:

You can use this device in a Digimap.



User interface:


Device information:

Go there to have more information on this device.

Need more help with this?
Don’t hesitate to contact us here.

Thanks for your feedback.