Choose this device to connect to a Phidgets Sound sensor SND1000_0
Measure sound from 34 to 102 dB (SPL).
Supports A and C weightings, and can split data into distinct frequency bands.
Settings:
| Name | User-friendly name |
|---|---|
| Enable | Activate to enable the device |
| Run at startup | Activate to run the device at Kinetic startup |
| Serial Number: | Enter the serial number of the VINT HUB Phidget |
| Port: | Choose port number of the VINT HUB Phidget |
| Data interval ms: | Choose the refresh interval in milliseconds |
Task action:
N/A
Task trigger:
Trigger a task according to the incoming parameter:
Entry:
Use the dB, dBA, dBC or specific frequency bands:
The following frequency bands are represented:
octaves 1 = 31.5 Hz
octaves 2 = 63 Hz
octaves 3 = 125 Hz
octaves 4 = 250 Hz
octaves 5 = 500 Hz
octaves 6 = 1 kHz
octaves 7 = 2 kHz
octaves 8 = 4 kHz
octaves 9 = 8 kHz
octaves 10 = 16 kHz
Condition:
| greater than | trigger the task when the incoming value is superior to the condition value |
|---|---|
| less than | trigger the task when the incoming value inferior,to the condition value |
| greater than or equal to | trigger the task when the incoming value is superior or equal to the condition value |
| less than or equal | trigger the task when the incoming value is inferior or equal to the condition value |
| eguals | trigger the task when the incoming value is equal to the condition value |
| range | trigger the task when the incoming value is superior to the condition value min and inferior to value max |
Value:
Set the condition value
Hysteresis:
For all theses conditions, you can set a hysterys value to avoid false triggering.
For example you use the > condition with a value of 0.5, you set an hysterys value of 0.1. When the incoming value reach 0.5, the task is triggered.
If the incoming value go back to 0.45 then go to 0.5, the task is not triggered.
If the incoming value go back to 0.35 (less than condition value – hystererys value) then go to 0.5, the task is triggered.
Digimap trigger:
Use the Db or DbA or DbC, or specific frequency bands as an input for digimap.
Graph:
| dB | get the dB measured |
|---|---|
| Octave 1 to 5 | get the dB measured for octave 1 to 5 |
| Octave 6 to 10 | get the dB measured for octave 6 to 10 |
User interface:
You can add this device in any user panel.
You can then choose the available features in the panel.
Device information:
Go to this page for more information.
You need to plug this device to a VINT HUB Phidget.
Need more help with this?
Don’t hesitate to contact us here.