Choose this device to control analog outputs and mesure analog values using Modbus with this device ADAM-6224


Name User-friendly name
Enable Activate to enable the device
Run at startup Activate to run the device at Kinetic startup
IP Enter the ip address of your device. Your device and Kinetic Designer need to be in the same subnet
Port TCP/IP port. 502 is the default value (usually doesn’t have to be changed)
Type Choose the ADAM-6224 or the generic Modbus version
Visual Mode Choose the visual mode (V or mA)
min Enter the minimal value of the range
max Enter the maximal value of the range

If you select Generic, you need to enter the following information:

Precision adjust the DAC precision (8/12/16 bits)
Inputs Number of digital inputs
Outputs Number of digital outputs
Start input address Modbus input register address
Start output address Modbus output register address

Task action:

Enable device enable the device
Disable device disable the device
Switch outputs Select the outputs you want to change and the corresponding values you want


Task trigger:


Digimap trigger:


User interface:




Device information:

You can use for example the ADAM-6224

Need more help with this?
Don’t hesitate to contact us here.

Thanks for your feedback.