Control any TCP/IP Modbus GPIO.
|Activate to enable the device
|Run at startup
|Activate to run the device at Kinetic startup
|Enter the ip address of your device. Your device and Kinetic Designer need to be in the same subnet
|TCP/IP port. 502 is the default value (usually doesn’t have to be changed)
|Choose the device from the list
If you select Generic, you need to enter the following information:
Nb input: The number of digital inputs
Nb output: The number of digital outputs
Start input address: Modbus input register address
Start output address: Modbus output register address
Use Coils feedbacks: Enables feedback ask to device (some devices don’t like this command so you can disable this behavior).
|enable the device
|disable the device
|Choose the task to switch some outputs
You can trigger a task when the selected inputs are in a specific state.
Need more help with this?
Don’t hesitate to contact us here.