Tracking hardware config

Select the proper serial COM port to connect to your device.

If you do not know which COM port to select, go to the Device Manager to find the serial port created when you plugged the first beacon.

Once selected, click on Connect.

Click on the Refresh button to refresh the list of available COM port.

Beacon setup

Set the radio channel.

For a proper sync, you need to have a matching radio channel between the beacons and the Active box receiver.

You can set the brightness of the LEDs.

A higher brightness will decrease the lifetime of the battery.

You can have more brightness if you enable only the first 4 LED and set the brightness to 100%.

Choose a batch id and click on Generate to set the LED IDs.

Click on Apply after doing a change to save the config in the beacon.

Active Sync box setup:

Set the radio channel.

For a proper sync, you need to have a matching radio channel between the beacons and the Active box receiver.

Click on Apply after doing a change to save the config in the receiver.