Setting a monitoring output can be useful to check incoming signals from a camera or a computer that you would like to include in your projection.
You can either setup the monitoring on one of the physical outputs of the V-Node or stream it over the network via NDI.
Adding a monitoring output
In the V-Nodes panel > Output section click on 
and select Monitoring.
Set the Out to (0;0) and the Size to 1920×1080.
Select the Monitoring output and in the Preset section (replaces the X-Map section), click on .
This will open the Preset tab in the Editor panel.
Set 3 rows and adjust the first two rows to have two columns using the + boxes in the top right corner of each row.
Drag & drop the Render Surface from the Render Surface panel in the first row.
Drag & drop the 4 live sources in the 4 boxes of the second and third rows.
Streaming monitoring to NDI
It is possible to stream the monitoring via NDI and not use a physical output on the graphics card of the server.
Select the Monitoring in the V-Nodes panel.
Check that the Out position is at (0;0) in the Output tab of the Editor panel.
Toggle the NDI Enable option.
Need more help with this?
Don’t hesitate to contact us here.